The camera comes with the default settings which allows you to start using your camera right out of the box without changing any settings. Make sure to format the memory card before first time use.
install REDTIGER F7N 4K Dash Cam
1. Installation Position-Most people will install F7N next to the rear view mirror and opposite side from the drive. First, Stop the engine where there is some light and in a safe place.
2. Make sure to clean your windshield from the dust particles and attack attach the electrostatic sticker to the windshield.
3. Peel off the 3M tape attached to the GPS built-in bracket and attach it on the electrostatic sticker on the windshield
4. Use the power cord to connect the micro USB Port of the product to car’s cigarette lighter socket.
install the rear camera
We recommend install the rear camera above the license plate.
1. Fix camera with 3M adhesive Find a best location, tear off the 3M adhesive on the rear camera, fix the rear camera near by the car license plate lamp. (if you need to adjust the angle, please attach the rear camera bracket to the rear camera and tighten it with screws first).
2. Remove the Panel
Remove your trunk’s interior panel to expose the cars rear wiring chambers.
Pop open your trunk and look for a solid interior panel covering the opposite side of your license plate mounting area. Then insert a trim removal tool or other thin device behind the panel and pry it off.
3. Snake the cable
Use a trim removal tool to pop out tailgate trim, then run the cable from outside of the car into the trunk of your car.
4. Connect the rear cameras power cable to the extension cable.
After snaking your rear camera’s extension cable, connect the power cable to your rear camera’s extension cord.
Note：The red wire on the rear camera cable does not need to be connected. (Designed for another model of our products)
5. Route your rear camera’s power cable to the front of the car.
If you’d like, use a trim removal tool to pop out the headlining panel directly above your windshield. Then, run your cable through the exposed chamber.
6. Power on the dash cam with box included car charger, don’t charge it with your own chargers.
Notes on installing the F7N 4K Dash Cam
Connect the cigar plug cord connector in the correct orientation. Connecting in the wrong direction may cause malfunction or damage. If you cannot connect successfully, check the connection part carefully before connecting.
Only use REDTIGER Car Charger, otherwise the camera may frequently reboot or flicker LCD due to insufficient power.
Make sure to remove the Plastic Lens Screen Protector from the lens before recording videos. Otherwise your videos will look blurry and blocked.
Do not remove the Micro-SD card while the camera is turned ON.Otherwise it may cause memory card to be write protected and possible loss of data or damage your memory card.
Always remove/insert memory card while camera is turned OFF.
Do not use Socket distributor.
Do not connect or disconnect the rear camera cable while the power is on. It will be the cause of the failure.
The rear camera has 180° Filp Function, you can flip the rear camera according to your needs.
How do I connect the back camera to a truck